Tube bender, high production. Can bend up to 1200 bends per hour. Tube manufacturing. Production tube bender. Exhaust tube and muffler manufacturing. Pipe bender.

Back to Service Index

Back to Home

Muffler page

www.allstates.com

MACHINE

BY-PRODUCT

DESCRIPTION

MODEL 100P-SADC2P

THE MODEL 100P-SADC2P IS A HIGH PRODUCTION TUBE BENDER. THIS UNIT CAN BEND UP TO 1200 BENDS PER HOUR BASED ON 90° BENDS. TUBE DIAMETERS VARY FROM 1/2" (12.7MM) TO 2" (50.8MM). IT OPERATES WITH (2) PALM BUTTONS AND HAS A PLC SYSTEM TO CONTROL ALL SEQUENCE OF OPERATION AUTOMATIC OR MANUAL. IT IS ELECTRICAL DRIVEN, HYDRAULIC POWERED. SPECIAL DIGITAL READOUT WITH 15 BEND PROGRAM CONTROL AVAILABLE. EXTRA LARGE HYDRAULIC RESERVOIR TO INSURE AGAINST OVERHEATING DUE TO THE SPEED AND PRESSURE. THIS UNIT GENERATES UP TO 20 TONS OF BEND FORCES. MAXIMUM BEND RADIUS 5" (127MM) MINIMUM BEND RADIUS 2.5" (63.5MM).

FEATURES

SPECIFICATIONS

HIGH PRODUCTION COMPRESSION TYPE TUBE BENDER
PRODUCTION RATES DEPEND ON AMOUNT OF GPM OF WHICH DEPENDS ON HORSEPOWER ON WHICH DEPENDS ON PRESSURE ON WHICH DEPENDS ON RESERVOIR CAPACITY
230 - 440 VOLTS, 3 PHASE, 50/60 CYCLE
24 VOLTS, 2 PALM BUTTON BEND CYCLE CONTROL
PLC SYSTEM TO CONTROL MANUAL OR AUTOMATIC BEND CYCLE
3000 PSI MAXIMUM HYDRAULIC SYSTEM PRESSURE
20 TONS OF BENDING FORCES
COMPLETE HYDRAULIC SYSTEM WITH SOLENOID VALVE, COUNTER BALANCE VALVE, FLOW CONTROL VALVE AND SAFETY RELIEF VALVE
BEND CYCLE TIME APPROX 3-4 SECONDS DEPENDING ON DEGREE OF BEND
MAXIMUM BEND RADII 6" (152.4MM) - MINIMUM BEND RADII 3" (76.2MM)
SEMI AUTOMATIC MANUAL SETTING OF EACH BEND DEGREE (OPTIONAL)
DIGITAL BEND CONTROL UP TO 15 BENDS (OPTIONAL)
OVERSIZE HYDRAULIC FLUID RESERVOIR
QUICK TOOLING CHANGEOVER AROUND 30 SECONDS
ALL TOOLING MADE FROM ALLOY STEEL AND HEAT TREATED
1/4" (6.3MM) TO 2" (50.8MM) BEND CAPACITY
178 MAXIMUM BEND DEGREE